Walls preprocessing
1. The walls must be clear of any pollutions like wallpapers, paint spots, dirt, dust etc.
2. The walls demands to be flat. After cleaning, it is necessary to putty the cavities and remove the ledges on the walls.
3. Hygroscopic surfaces and surfaces which absorbs moisture (gypsum, wood, plywood etc.) are must be processed with special waterproof substance on purpose of avoiding the mold and
other defects which appear due to extra humidity.
4. After the surface gets dried, the dust and other kind of pollutions must be removed from the surface. Then apply the deep penetration primer on the surface. 5. The surface must be dry, flat, solid and tough.
6. Before to apply the wallpapers make sure that surface is completely dry.
Choose the glue
7. We recommend using glue for wallpapers on non-woven base.
8. The glue is must be applied only on the wall!
9. Do not apply too much glue on the wall to avoid excess humidity of wallpapers and avoid glue flowing through the borders of wallpapers.
Important!
10. Do not allow the glue flows on the wallpapers. Excess glue must be softly removed by wet sponge.
11. The best way to smooth the wallpapers is rubber roller. We do not recommend to use steal putty knife and wet rog because of avoiding the damage of the wallpapers.
12. All processes are must be done only after you sure that all windows and doors in the room are closed. It is necessary to provide an absence of the wind drafts and temperature drops. Glue
takes 12-24 hours to get dry completely. Dry time depends of specific of the room where the wallpapers are getting applied.
Getting started:
Kindly ask you to read first before start the process!
1. Check the integrity of containment of the parcel.
2. Check out if wallpapers, which arrived to you, match to the wallpapers you ordered.
3. Expand the wallpapers like joint to joint on the floor.
4. Check out if the wallpapers include any kind of damage or any kind of defects.
5. If any kind of defects are spotted, please contact to us.
6. Before sticking the wallpapers leave them in the room where they must be applied for about 2 hours long. 7. We recommend doing all the processes at 18-25 C (64-77 F) temperature in the room.
8. Make sure that the walls are not too cold.
Wallpaper sticker scheme
• Set the vertical reference point on the wall to stick the wallpapers strain.
• Assembly the wallpapers on the floor to check out how does completely painting looks
to right.
• The wallpapers are stuck on wall like joint to joint. Each canvas of the wallpapers stick
• The glue is must be applied on the wall in order of the size of piece of the wallpaper. To apply nice strain lay of the glue we recommend touse lint roller.
• Do not allow the excess wetting of the wallpapers.
• Do not allow the excess glue accumulates into lumps or air bubbles in front and back side of the wallpapers. Remove them gently by a rag.
• Stick the first canvas to the wall along the vertical reference point.
• The canvases are must be smoothed and rolled with a dry and clean rubber roller. Remove excess glue and air bubbles.
• Do not allow folds and any kind of damage to appear on the wallpapers during the process.
• Excess ledges of the wallpapers are must be carefully cut with a help of keen steal knife or any kind of keen device. Avoid an excess pressure on the wall to don't damage the surface of the
wall. Provide absence of the wind drafts before the wallpapers completely dried. • The result will be ideal if the installation was done accuracy.
